Knowledge Base:  

You are here: Knowledge Base
Page of 1
14T BBX
for GQ43VT14T for HYQ12BBX, HYQ12BAN, HYQ1512Y Please make sure to read through the programming instructions completely before attempting. All remotes that are expected to work for t
20T
2010+ model years are dealer program onl 2008+ Tundra dealer program only 2008+ Highlander dealer program only Your vehicle must use this style remote, this remote is not compati
512
You must have one (1) factory key that can start the vehicle to perform this procedure. If you do not have one (1) factory key for the vehicle currently, a trip to a dealership or an au
523 H2T
Remote Programming : Please make sure to read through the programming before attempting. All remotes that are expected to work for the vehicle will need to be with you in the v
CP
NOTE: Key must be cut by a locksmith prior to using these instructions Programming with a working key: 1. Insert an existing programmed working key into the ignition
F80
Transponder Programming : Two working original keys are required to program a third. Dealer/locksmith programming required if you only have one working key. Unprogrammed new keys do not
FRD
Standard Remote Programming (for most models, if this does not work, please try alternate programming instructions located below) All remotes that are expected to work for the vehicle
FRG
Please read the information below prior to programming: 2010+ vehicles require dealer or locksmith programming, for 2009 Dodge Ram dealer or locksmith programming is required You
L4C
Key must be laser cut by a qualified auto locksmith or dealer before programming. An existing MASTER key is required, if you have a grey valet key this procedure will not work. Dea
LHJ MYT
Collect all remotes that you wish to program. This procedure will erase all previously programmed remotes. You must program all existing and new remotes that you wish to use on the
NIS
Remote Programming: Please make sure to read through the programming instructions completely before attempting. All remotes that are expected to work for the vehicle will need to b
OHT
Please make sure to read through the programming instructions completely before attempting. You must have two (2) factory keys that can start the vehicle to perform this proc
OUC
2011+ model years are dealer program only! If your vehicle will not enter programming mode confirm you do not have a check engine or tire pressure warning on. Any warning
RS3
To program (add) a remote control to the system: 1: Insert the key into the ignition switch and turn it to on. 2: Press and hold the ECU's programming switch for 3 seconds. The