KEY PROGRAMMING

Please make sure to read through the programming instructions completely before attempting.

You must have a black original master key to perform this procedure. If you have a grey key, or you do not have a key at all, a trip to a dealership or an automotive locksmith will be required for the programming.

1. Enter the vehicle, close and unlock all doors using the power lock switch on the driver’s door.

2. Insert your original black key into the ignition switch but do not turn the key.

3. Within fifteen (15) seconds, using the accelerator/gas pedal, press and release the pedal five (5) times.

4. Within thirty (30) seconds, using the brake pedal, press and release the pedal six (6) times.

5. Within ten (10) seconds, remove the key from the ignition switch then insert the new key to be programmed but do not turn the key. Using the accelerator/gas pedal, press and release the pedal one (1) time.

At this point the immobilizer warning lamp will begin to flash for one (1) minute (The immobilizer lamp is a small red circular light, or a small red car shape with a key light, located on your dash display or next to the steering column). After one (1) minute has passed, this light will stop blinking, indicating that the new key has been successfully programmed.

6. Additional keys must be programed within ten (10) seconds by repeating STEP 5.

7. Once you have programmed all the keys, exit the programming mode by removing the key that is currently in the ignition, then press and release the brake pedal one (1) time. You can program up to seven (7) keys at one time.

8. Test all keys to ensure they are functioning. If any did not program, restart the programming procedure from STEP 1.